
Version 1.00
Initial Version.

Version 1.01
1. Modify the USB PID code to be determined by define
2. Modify the value setting method on the MENU page (add value button action)
3. Fixed the issue where pressing the button too quickly during startup would cause the button to no longer be triggered
4. Modify the Auto Function DIODE and OHM judgment mechanism
5. Modify some SCPI commands

Version 1.02
1. Added PID Code identification for ODM HOPE
2. When the Temp sensor type is changed, contv() is not recalculated, resulting in inaccuracy
3. Fixed the issue where Function Info was not updated when the Temp sensor type was changed
4. Modify the Freq function to clear the value when switching the Measure option
5. Modify the text on the Interfacec screen (change Protocol to Protocol)
6. Fixed the issue where the measured value would be 0 when the AutoFunction function was canceled
7. Fixed the issue that caused the buttons to become ineffective when two buttons were quickly switched at the same time.
8. Modify the HiZ Icon position (when the db or dbm function is turned on, the position will overlap)
9. Fixed the issue where the last digit of Math value setting would be 0
10. Modify the scpi command calc:db:ref return and setting to follow RefMethod
11. Fixed the problem that the TMC test could not be performed by continuous command using LabVIEW
12. Fixed the problem that scpi cannot return continuous commands
13. Fixed the problem that GPIB address cannot be set to GPIB card
14. Modify the word "GetTime" (Change GetTime to GateTime) 
15. Modify the single display font size (84 to 90)
16. Modify MODEL_NAME_NUM_MAX length (10->15)

Version 1.03
1.Fixed the issue where the FloatToLong() function would cause incorrect value unit conversion
2.Fixed the issue that the machine would reboot when USB HOST encountering a slow USB flash drive

