== FOR 3KA===
Version 2.33
Initial Version.

Version 2.34
Prevent AD633 make mistake at“Middle Range”

Version 2.35
When switching range, draw an outer frame again

Version 2.37
panel phase out

== FOR 3KAE===

Version 2.10
Initial Version.

Version 2.11
When switching range, draw an outer frame again

Version 2.12
panel phase out

== FOR 3KAH===
Version 2.09
Initial Version.

Version 2.10
Prevent AD633 make mistake at“Middle Range”

Version 2.11
When switching range, draw an outer frame again

Version 2.12
panel phase out

== FOR 3KA&3KAE&3KAH===
Version 2.41
1.USB Information(PID/VID/SerialNumber)
2.enhance response time
3. 3. At 10.00V, there will be image retention problems
4. Image retention problem caused by scpi command
5. Issues with editing SEQ. through scpi commands

Version 2.42
1. Current overshoot issue after loading terminated(for PEL3KA)
2. mask address in UART mode

Version 2.43 (skipped no release)
1. reduce show Sequence Paused area(N.Seq)
2. modify factory reset value(UTILITY.MeasureVerage = 1)

Version 2.44
1. In parallel mode, when the analog signal received by the host is zero, the host must load off.

Version 2.45
1. Support mDNS only

Version 2.46
1.	When setting value in cp+cv mode, it should remain in the original mode
2.	Only in stand-alone mode, load off will occur when an external trigger occurs.






















